Table of Contents
Advertisement
Modifying the object tables
Modifying the 18 cm x 24 cm object table for thick
cassettes
If thick cassettes are to be used, the 18 cm x 24 cm object table must be modified as fol-
lows (see also separate instructions enclosed with the object table).
3
Figure 1 Modifying the object table
1
Remove the carbon-fibre plate (1) by unscrew four long screws (2) on the top side
and four short screws (3) on the front side.
2
Remove the four screws (4), two on each side.
3
Withdraw the steel bottom plate (5) and the spacing plate (6).
4
Install the new steel bottom plate and spacing plate included in the package.
Be careful with the switch and wire (7). Make sure that the switch actuator (8) is in
proper position.
5
Fasten with screws (4), two on each side.
NOTE!
It is recommended that the spacing plate and bottom plate not in use be kept for future
need.
6
Mount the carbon fibre-plate (1) and pay attention to the brass grounding strap (9).
NOTE!
Before mounting the carbon-fibre plate, make sure that the grid is properly positioned on
the support (10).
Siemens-Elema AB
Solna, Sweden
1
4
10
SPS-UD
RX B7-120.033.01.10.02
9
5
6
05.98
6-1
2
8
7
5
MAMMOMAT 300
65 02 186
Advertisement
Table of Contents
