Checking The Swivel-Arm System; Rotary Motion - Siemens MAMMOMAT 300 Installation And Start-Up Instructions Manual

Checking the swivel-arm system

Rotary motion

1 System "OFF".
The rotary motion and the vertical adjustment of the swivel-arm system shall be
blocked.
Figure 1 Swivel-arm system
2 System "ON", object table installed and set projection angle to minimum with preset-
ting knob (2).
3 Check the rotary motion of the swivel-arm system by pressing buttons (1) one by one.
The rotation of the swivel-arm system shall stop when the button is released or when
end position is reached (+135 degrees clockwise and -180 degrees counter-
clockwise). The projection angle is shown on the display at the lower part of the
stand.
Siemens-Elema AB
Solna, Sweden
1
3
SPS-UD RX B7-120.033.01.10.02
2
1
4
3
05.98
14-1
MAMMOMAT 300
65 02 186