Table of Contents
Advertisement
Installing the generator and the stand
3
Fit the cable duct cover (5) on the cable ducts.
Aligning the stand
1
Align the stand vertically by means of the levelling screws (1) .
For adjustment of the levelling screws, use a ratchet spanner 1/2" with extension
(without socket).
NOTE!
It is important that all six levelling screws bear against the floor to ensure optimum sta-
bility of the stand.
2
Cover the levelling screws with the cover discs supplied.
Figure 5 Levelling screws
NOTE!
If bolting to the floor is required, please refer to section 20 page 1.
Siemens-Elema AB
Solna, Sweden
SPS-UD
RX B7-120.033.01.10.02
1
05.98
4-5
MAMMOMAT 300
65 02 186
Advertisement
Table of Contents
