Angelcare AC127 Owner's Manual page 12

4. Turn the Parent Unit ON. The Out-of-range icon
Nursery Unit is in linking mode)
5. Press and hold the Talk Back button on the Parent Unit until a beep tone
is heard
6. Press OK button on the Parent Unit. The Out-of-Range icon
faster to indicate that the Parent Unit is in linking mode
LOSS OF CONNECTIVITY BETWEEN THE SENSOR PAD AND THE NURSERY UNIT
• In the case of loss of connectivity, the first step is to bring the Sensor Pad and Nursery Unit closer together and make
sure that both units are ON to restore the connection. If there is still no connection after the above has been done, then
and only then should the re-connection procedure below be done. Make sure that no other wireless Sensor Pad is in the
same room during the reconnection procedure.
1.
Turn Nursery and Parent Units OFF
2.
Remove and replace the battery from the Sensor Pad
3. Turn the Nursery Unit ON by pressing 2 seconds on the Power
ON/OFF button
Power Indication of the Nursery Unit
will turn green
4. Press and hold the Pause button on the Nursery Unit
for 3 seconds
The Sensor Pad indicator Light of
the Nursery Unit will flash blue
BLUE
• The reconnection should be completed within 30 seconds.
• The reconnection is successful when Nursery Unit sounds a confirmation tone.
MOVEMENT SENSOR PAD - NO ALARM
• Sources of vibration & movement other than your baby's can be detected by the Sensor Pad and the alarm will not sound.
• Refer to Warnings 3 to 11 and see STEP 4, TEST THE SENSOR PAD.
MOVEMENT SENSOR PAD - FALSE ALARMS (SENSOR PAD LIGHT INDICATOR FLASHING RED)
• Replace the Sensor Pad battery CR2450.
• Turn OFF the Nursery Unit.
• Sensor Pad False alarms may happen for several reasons , always be sure to immediately check on baby whenever
an alarm sounds:
- Nursery Unit has not been turned OFF after you have removed your baby from the cot
- Make sure there is no bedding between the mattress and the Sensor Pad
- Sensor Pad has not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, firm surface
with the printed side facing up
- The sensitivity level may also need to be adjusted
• Refer to Warnings 3 to 11 and see STEP 4, TEST THE SENSOR PAD
12
will blink (indicates
should blink
• The Parent Unit will display H1-H2 icon during the reconnection
procedure
• The reconnection is successful if Parent unit shows regular
screen view
3
5
6
4