Page 1
Philips Screwdriver STEP 1 – INSTALL APPLICATION 1) Scan QR Code with your smartphone OR Search for Angelcare baby monitor in your App Store. 2) Open application and accept PUSH Notifications. 3) Sign up and create your account.
Page 2
VIA ACCESS POINT SETUP (No Internet connection needed) 1) Set camera to AP mode (switch underneath camera) 2) Select Angelcare camera via your WiFi settings device using password: 12345678 3) Restart the app (if it does not work immediately) 03Bmf2_QuickInstallation_AC1200_EN_11807.indd 2...
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 5
Sensor Pad Introduction Spec: Dimension: 240*240*10mm 2M length cable with 3.5mm pin Piezoelectricity to detect vital signs Function: Connect to Babycam by 3.5mm pin. Baby lies down on the sensor pad, once baby without vital signs, pad will send signal to Babycam for alarm.