Function Installation Steps - AMD 770 User Manual

4-10 G.P.I. Function Installation Steps
Operating Steps:
The Default setting in BIOS has already enabled this function. If you wish to change the
settings, please enter BIOS and take the following steps:
Select: Advanced BIOS Features→CPU Configurations→AMD Cool&Quiet Control:
AUTO/Disable(This function control the power saving mode: set it as Enabled) →GPI
Function:（set as Enabled）
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Standard BIOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management Features
Miscellaneous Control
Hardware Health Configure
↑↓→← : Move Enter: Select +/-/: Value F10: Save ESC:Exit F1:General Help
F5: Previous Values F6: Optimized Defaults F7: Standard Defaults
V02.65(C)Copyright 1985-2008, American Megatrends. Inc.
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Advanced Settings
WARNING: Setting wrong values in below sections
May cause system to malfunction
CPU Configuration
Boot Sector Virus Protection
Hard Disk Drives
Removable Drives
Quick Boot
ST
1 BOOT Device
nd
2 Boot Device
Boot up Num-Lock
ACPI APIC Support
MPS Revision
Quiet Boot
↑↓→← : Move Enter: Select +/-/: Value F10: Save ESC:Exit F1:General Help
F5: Previous Values F6: Optimized Defaults F7: Standard Defaults
Thermal Throttling Function
Power User OverClock Settings
BIOS Security Features
Load Optimal Defaults
Load Standard Defaults
Save Changes and Exit
Discard Changes and Exit
[1]
Advanced BIOS Features
Press Enter
Disabled
Press Enter
Press Enter
Enabled
st
1 Floppy Drive
HDD: PM-WDC WD800
On
Enabled
Enabled
Disabled
[2]
44
Help Item
Configure CPU