Leica 2-Arm Led Spotlight - Leica F12 I User Manual

Leica 2-arm LED Spotlight

The Leica 2-arm LED spotlight is equip-
ped with two LED lamps. It only uses one
terminal, however, on the Leica combi control-
ler.
For installation, the focusing arm must
be removed. In doing so, request assis-
tance from another person and be sure that
the specimen is not located directly below the
microscope.
The LEDs of the Leica 2-arm LED spot-
light become only slightly warm during
operation. Nevertheless, be sure that the speci-
men cannot be damaged by coming too close
to the light.
Leica F12 I Floor Stand
Assembly
1. If the focusing arm has already been
installed, remove it (see pages 17–19).
2. Screw the installation ring onto the spot-
light.
Manual
3. Slide the installation ring over the small
horizontal arm and tighten the locking
screw.
4. Install the focusing arm.
5. Connect the power pack for the spotlight to
the Leica combi controller.
5. Secure the cables using the Velcro strips
provided so that the cables cannot get in
the way during work.
36