Do's And Don'ts - FiberHome AN6000-7 Quick Installation Manual

16
Dos and Don'ts
Do not install / operate the
equipment or lay cables
during a lightning storm.
Vacant slots should be
covered with dummy
panels to prevent foreign
objects from entering the
equipment and ensure
normal air circulation.
When plugging / unplugging
a card, exercise care and
align the card with slide
rails.
Install rat guards at the top
and bottom of a cabinet or
fasten mouseproof hop-
pockets after connection
of cables is completed.
Do not connect or remove
power cables while they
are powered.
Power cables should be
separated from signal
cables.
Put an anti-dust cap on an
unused optical fiber.
Keep cabinet
doors closed in
daily operations.
Direct or indirect contact
(through damp objects) with
high voltage power supply
can cause bodily harm and
should be avoided.
Do not bind optical fibers
with cable ties. Use the
black fiber binding strap
instead.
Put an anti-dust cap on an
unused optical module.
Do not place
labels between
two cards, which
may affect the
electrical
conductivity
between the
cards.
23
23
Promptly report any
conditions that may lead to
security problems.
Tidy up big bundles of
cables, and avoid crossing
or twisting them whenever
possible.
Do not twist, bend, stretch
or squeeze optical fibers
during installation. The
bending radius of optical
fibers should be no smaller
than 10 D.
Reserve proper margins
between cable connectors
and the first binding points,
so that cables can be easily
plugged or unplugged and
that stress will not be
produced at the connecting
points.