Dn Setting; Setting Indoor Unit Dn Codes (I.dn) - Toshiba RBC-AMTU31-E Owner's Manual

8

DN setting

 Setting indoor unit DN codes
(I.DN)
How to set an indoor unit DN code from
the wired remote controller
3
4
7 5 1
1
Push + +
for 4 seconds or more.
(In the case of group control, the "UNIT No."
displayed first is the number of the header unit.)
2
In the case of group control, push
(left side of the button) to select the No. of
the indoor unit whose address you want to
change.
The fan and louver of the selected indoor unit start
to operate.
3
Specify "CODE No." with
• If you select a 3-digit code, the display will be as
follows, and the 3rd digit will be displayed where
the "UNIT No." was displayed.
• If you want to check the "UNIT No.", push
(left side of the button). The "UNIT No."
display flashes three times. After the third
flashing, the display returns to the third-digit
display.
2, 6
buttons simultaneously
buttons.
3-digit code
4
Use buttons to change the setting
being displayed to the desired setting.
5
Push button.
6
After making the above change, push
(left side of the button) to check the
new setting.
7
Push the button to finish the setting.
Owner's Manual
22-EN