Toshiba RBC-AMTU31-E Owner's Manual page 16

◆ Setting the louver lock
1
Push and hold the
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the UNIT LOUVER
button) to select a unit.
The unit number changes each time you push the
button.
Unit No.
1-1
The fan of the selected unit runs, and the louver
swings.
3
Push the
number of the louver to fix its direction.
The selected louver swings.
4
Push the
direction of the louver you do not want to
swing.
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the
When the setting is confirmed, the
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the
15-EN
button (right side of
UNIT LOUVER
button (left side of the
Unit No. Unit No.
1-2 1-3
Unit No.
1-4
buttons to display the
buttons to select the
(1) (2) (3)
0001 0002 0003
(4)
(5)
0004
0005
button to confirm the setting.
button to finish the setting.
* [F1] appears in the "CODE No." section on the
remote controller. This indicates that the louver
[01] shown in the following figure is selected.
4-way cassette type
Refrigerant
pipe
Drain pipe
Compact 4-way cassette type
04
mark lights
[0001] - [0005]
(Louver position
code)
Electrical control box
03
04
01
03
01
Refrigerant
Drain pipe
pipe
Owner's Manual
Louver No.
02
02