8°C Operation - Toshiba RBC-AMTU31-E Owner's Manual

 8°C operation
Pre-heating operation can be set for cold regions
where room temperature drops to below zero.
1
Push + +
for 4 seconds or more when the air
conditioner is not working.
After a while, the display part flashes as shown
below. Check the Displayed "CODE No." is [10].
• When the "CODE No." is other than [10], push
button to erase the display and repeat
procedure from the first step.
(After pushing
remote controller is not accepted for approx. 1
minute.)
The content of "SET DATA" displayed with
"CODE No." [10] changes depending on the type
of indoor unit.
2
Every time
indoor "UNIT No." in the group control is
displayed in order. Select the indoor unit of
which setup is changed. In this time, the
position of the indoor unit of which setup is
changed can be confirmed because fan of
the selected indoor unit operate.
3
Specify "CODE No." [d1]
4
Select "SET DATA" [0001]
SET DATA
0000
0001
5
Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
6
Push button. (Setup is determined.)
When button is pushed, the display
disappears and the status becomes the usual stop
status. (When button is pushed the operation
from the remote controller is not accepted for
approx. 1 minute.)
buttons simultaneously
button, operation of the
button is pushed, the
buttons.
buttons.
8°C Operation setting
None
(Factory default)
8°C Operation setting
Owner's Manual
18-EN