Fujitsu Siemens CELSIUS 4 Series Operating Manual page 43

Installing and removing a board
Installing board with screws
Ê
Open the workstation (see "Opening the workstation").
1
Ê
Undo the screw (1).
Ê
Remove the rear slot cover plate from the slot (2).
Do not dispose of the cover plate. For cooling, protection against fire and in order to
!
comply with EMC regulations, you must refit the cover plate if you remove the board.
Ê
Take the new board out of its packaging.
Ê
Make the required settings for the board.
Ê
Push the board up to its slot (3).
With long boards, please observe:
-
The side of the board without a metal angle bracket must lie in the corresponding guide of
the casing.
-
The point of the angle bracket must engage in the guide.
Ê
Press the board into the slot so that it engages.
Ê
Tighten the screw (1) for holding the board.
Ê
If necessary, connect the cables.
Ê
Close the system unit (see "Closing the Workstation").
A26361-K547-Z400-1-7419
System expansions
English - 35