Important Notes; Safety; Notes On Installing And Removing Boards - Fujitsu Siemens CELSIUS 4 Series Operating Manual

Table of Contents

Important notes

In this chapter you will find information regarding safety which it is essential to take note of when

working with your workstation. The manufacturer's notes contain helpful information on your

workstation.

Pay attention to the information provided in the "Safety, Warranty and Ergonomics"

booklet and to the following notes.

During installation and before operating the device, please observe the instructions on

environmental conditions in the chapter entitled "Technical data" as well as the instructions in

the chapter "Preparation for use and operation".

Please check whether the device is correctly set for the local power supply (see "Preparation

for use and operation" chapter).

The main switch and the ON/OFF switch do not disconnect the workstation from the mains

voltage. To completely disconnect the mains voltage, remove the power plug from the

grounded mains outlet.

Replace the lithium battery on the system board in accordance with the instructions in the

"System expansions - Replacing the lithium battery" chapter.

Caution: components in the system can get very hot.

Keep this operating manual together with your device. If you pass on the device to third parties,

you should include this manual.

A26361-K547-Z400-1-7419

Boards with electrostatic sensitive devices (ESD) are identifiable by the

label shown.

When you handle boards fitted with ESDs, you must, under all

circumstances, observe the following points:

You must always discharge static build up (e.g. by touching a

grounded object) before working.

The equipment and tools you use must be free of static charges.

Remove the power plug from the mains supply before inserting or

removing boards containing ESDs.

Always hold boards with ESDs by their edges.

Never touch pins or conductors on boards fitted with ESDs.

English - 3

Table of Contents