Table of Contents
Advertisement
2.3
Laws and directives
General requirements
Installation of the equipment must comply with national regulations. For example, the
National Electrical Codes.
Instrument safety standards
The device has been tested at the factory, based on the safety requirements. In order to
maintain this condition over the expected life of the device the requirements described in
these Operating Instructions must be observed.
NOTICE
Material compatibility
Siemens can provide assistance with the selection of sensor parts. However, the full
responsibility for the selection rests with the customer and Siemens can take no
responsibility for any failure due to material incompatibility.
CE marked equipment
The CE-mark symbolizes the compliance of the device with the following Directives:
● EMC-Directive 2004/108/EC
● Low voltage Directive 2006/95/EC
● ATEX Directive 94/9/EC
FUE1010 IP65 NEMA 4X
Operating Instructions, 12/2014, A5E03086491-AC
Safety notes
2.3 Laws and directives
13
Advertisement
Table of Contents
