3. Installation
3.7
UPS connection without HotSwap MBP module
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power
source and the true electrical consumption of the total load.
Note. The UPS charges the battery as soon as it is connected to the AC-power source, even if
is not pressed.
Once the UPS is connected to the AC-power source, eight hours of charging are required before the
battery can supply the rated backup time.
Page 22
7
1
15
6
5
16
19
1. 9PX 1000I / 1500I : connect
the UPS input socket
1
AC-power source using the cable
of the protected equipment.
9PX 2200I / 3000I: connect the
supplied cable
(250 V -
15
16 A) to the socket
, then
1
to the AC-power source.
2. Connect the loads to the UPS
using the cables
.
16
It is preferable to connect the
priority loads to the outlets
marked
and the non-priority
5
loads to the outlets marked
that can be programmed.
For the 9PX 2200I / 3000I models,
connect any high-power devices
to the 16 A outlet.
To program shutdown of outlets
during operation on battery
6
7
power and thus optimise
the available backup time,
please check the in/out settings.
3. Fit the connection securing system
that prevents the plugs from
19
being pulled out accidentally.
button
9PX 1-3 KVA EU_EN
to the
6
7