Connecting The Ebm(S) - Eaton 9PX 1000i Installation And User Manual

3. Installation
• If you ordered an optional Extended Battery Module (EBM), verify that the following additional items are
included with the EBM:
2
Discard the EBM user's guide if you are installing the EBM with a new UPS at the same time.
Use the UPS user's guide to install both the UPS and the EBM.
If you ordered other UPS accessories, refer to specific user manuals to check the packing
contents.
3.3

Connecting the EBM(s)

A small amount of arcing may occur when connecting an EBM to the UPS. This is normal and
will not harm personnel. Insert the EBM cable into the UPS battery connector quickly and firmly.
1. Plug the EBM power cable(s) into the battery connector(s). Up to 4 EBMs may be connected
to the UPS.
2. Verify that the EBM connections are tight and that adequate bend radius and strain relief exist for each
cable.
3. Connect the battery detection cable(s) to the connector of the UPS and of the EBM(s).
9PXEBM48RT2U
Page 18
1
2
3
4
4
Battery power cable, attached with battery
detection cable
Stabilizer bracket (4 screws included)
Rack kit for 19-inch enclosures (optional)
EBM Installation manual.
1
3
9PX 1-3 KVA EU_EN