Troubleshooting - AEG BCK330050M User Manual

9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
One of the hinge-arms
(normally the right one) is
free to move. Make sure,
that both hinge-arms are in
the same position
(approximately 70° angle).
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.

10. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
9.5 Replacing the lamp
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 570
°F heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is deactivated.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
WARNING!
Risk of electric shock.
The lamp can be hot.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
ENGLISH 23