Panel Support Bracket With And Without Spacer Installation - KI Unite Panel System Assembly Instructions Manual

Unite Panel System - Worksurface with Pedestal Support Installation
®
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Panel Support Bracket with No
Spacer Installation
1. Position the panel support
bracket squarely along the top
and side edge of the pedestal as
shown, making sure that the teeth
are facing up (Figure 23).
Caution: Care should be taken
to ensure that the bracket is
aligned square with the top and
side of the cabinet for cosmetic
integrity and safe installation
of the worksurface. Laying
the cabinet on its side on a
smooth clean surface can aid
in alignment of the bracket for
installation.
Note: For left-hand installations
align the bracket with the left side
of the cabinet. For right-hand
installations align the bracket
with the right side of the cabinet
(Figure 23).
2. Using the four #10 x / "
3
4
self-drilling sheet metal screws,
carefully secure the bracket to the
cabinet (Figure 23).
Panel Support Bracket with
Spacer Installation
1. Position the spacer along the top
and side edge of the pedestal as
shown (Figure 24).
Caution: Care should be taken
to ensure that the bracket is
aligned well with the top and
side of the cabinet for cosmetic
integrity and safe installation
of the worksurfaces. Laying
the cabinet on its side on a
smooth clean surface can aid
in alignment of the bracket for
installation.
Note: For left-hand installations
align the bracket with the left
side of the cabinet with the studs
facing right. For right-hand
installations flip the bracket over
and align the bracket on the right
side of the cabinet with the studs
facing left.
18
2. Properly align the spacer to the
top and side of the pedestal and
use four #12 x / " self-drilling
3
4
sheet metal screws to secure the
spacer to the cabinet (Figure 24).
3. Position the teeth of the panel
support bracket face-up and
slide the support bracket to the
threaded studs on the spacer. Use
four / -20 KEPS nuts provided to
1
4
secure bracket to spacer
(Figure 24).
"
#10 x / 3
4
self-drilling
sheet metal screws
"
#12 x / 3
4
self-drilling
sheet metal screws