EFI Pro 32r Operation Manual page 154

You must ensure that there is enough media on the core so that the media
does not detach from it at the end of the Side B printing. If you choose Yes
on the prompt, the media advances by 50 cm before printing starts. If you
choose No, printing starts immediately.
The first line indicates the start of Side B print. As the media will be upside
down when you print Side B, you will not be able to see this line. Therefore
you should make two slits in the media, exactly on that line, one on the
left and one on the right.
The second line indicates where to cut the media, so that you leave
sufficient margin to load it on the Printer to print Side B.
NOTE: It is recommended to take an extra space (±1 meter) from the
second line.
6. Cut the media to release it from the Printer.
NOTE: Do not change Double side settings in Preferences after
printing Side A. Do not change the Job settings, except for the
Backside check box.
Document ID: OMM-00165 Rev. C Pro 32r Operations Guide
Double-sided Printing
2nd Line
1st Line
Figure 7-18 Print Side A
154