Chapter 3 Configuration
3.2.1 VME Boot
The VM162/VM172 normally boots from the FLASH memory on the DM60x piggyback. In some ap-
plications it may be useful to boot either from the VMEbus or the optionally assembled EPROM.
Jumper
J1
3.2.2 ROM Boot
Jumper
J2
3.2.3 Protective Ground - Signal Ground
Jumper
J8
3.2.4 VME SYSRES*
As long as the 5V supply is not within the VMEbus specification, the VM162/VM172 uses the VMEbus
RESET line. This behaviour may not be wanted in multi-master configurations and can be disconnected.
Jumper
J10
Juli 23, 1997
Setting
Description
Open
Boot from VMEbus enabled
Set
Boot from VMEbus disabled
Setting
Description
Set
Boot from boot ROM enabled
Open
Boot from boot ROM disabled
Setting
Description
Set
Protective ground connected to signal ground
Open
Protective ground disconnected from signal ground
Setting
Description
Set
On-board RESET generator to VME
Open
On-board RESET generator disconnected from VME
© PEP Modular Computers
VM162/VM172
Default
Default
Default
Default
Page 3- 5