Turning The Unit On And Off; To Turn Off - Mitsubishi Electric MJ-E82GH-H Instruction Manual

Turning the Unit ON and OFF

To turn ON
To start dehumidifying, select the desired mode.
The dehumidifier does not activate for
3 minutes when the unit is turned ON
immediately after turning it OFF or plugging it
into the power socket. (In order to protect the
compressor.) When dehumidifying begins,
the operational noise increases.
The dehumidifier remembers the operating mode.
Even if the plug is disconnected or the power
turned off, the unit restarts at the previous setting.

To turn OFF

Drying inside will commence if it has been
activated.
The unit can operate in a room temperature range of
1-35°C. However, if the room temperature exceeds
35°C, the unit may operate in blower mode or
increase the airflow. This is because the temperature
within the unit rises causing the protection mechanism
to operate. In order to lower the temperature within the
unit, when using the louvre, point UPWARD.
• If the temperature is below 1°C, the extracted water is
close to freezing disabling the dehumidifier, and only
the blower is operational.
CURRENT indicates the
Example
current humidity.
Current humidity range is
between 30–80%.
• Humidity levels below 30% are
displayed as 30%.
• Humidity levels above 80% are
displayed as 80%.
Example
SELECTION indicates set
humidity level
(Auto mode only).
The unit automatically shuts down and indicates
with the lamp and sound that the water tank is full.
Empty the water tank.
• After removing the water and replacing the tank,
the Tank full lamp will go off, and the unit will
automatically return to operation mode.
• When the Tank full lamp is lit, no operation but ON/
OFF is possible.