Turning The Unit On And Off - Mitsubishi Electric MJ-E22WX-H Instruction Manual

Table of Contents

Advertisement

Turning the Unit ON and OFF

To turn ON
¡Power lamp lights.
¡The mode is displayed.
¡The louvre opens automatically.
To start dehumidifying, select the desired
mode.
13~15
The dehumidifier does not activate for 3 minutes
when the unit is turned ON immediately after
turning it OFF or plugging it into the power
socket. (In order to protect the compressor.)
When dehumidifying begins, the operational
noise increases.
The dehumidifier remembers the operating
mode. Even if the plug is disconnected or
the power turned off, the unit restarts at
the previous setting.
To turn OFF
Press
Internal cleaning will commence if it has
been activated.
∞ If the room temperature falls below 15°C,
defrosting mode is activated once every 40
minutes (for about 5 minutes) causing water
to drain to the tank.
∞ The unit can operate in a room temperature range of 1-35°C.
However, if the room temperature exceeds 35°C,
the unit may operate in blower mode or increase
the airflow. This is because the temperature within
the unit rises causing the protection mechanism to
operate. In order to lower the temperature within
the unit, when using the louvre, point UPWARD.
• If the temperature is below 1°C, the extracted
water is close to freezing disabling the
dehumidifier, and only the blower is operational.
12
Press
¡Power lamp turns off.
¡The Mode Indicator
goes out.
17
9
Reading the humidity display
CURRENT indicates the
Example
current humidity.
Current humidity range is
between 30-80%.
• Humidity levels below 30%
are displayed as 30%.
• Humidity levels above 80%
are displayed as 80%.
Example
SELECTION indicates set
humidity level
(Automatic mode only).
Tank full lamp
The unit automatically shuts down and
indicates with the lamp and sound that
the water tank is full. Empty the water
tank.
21
¡Tank full lamp lights.
(The unit beeps continuously).
¡Air flows stops (louvre stops).
¡Monitor turns off.
• After removing the water and replacing the
tank, the Tank full lamp will go off, and the unit
will automatically return to operation mode.
• When the Tank full lamp is lit, no operation but
ON/OFF is possible.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents