Standard Specifications; How To Order - SMC Networks ITV1000 Series Manual

Straight type Right angle type
JIS Symbol
Rated pressure
This range is outside
of the control (output).
0.005 MPa
0
0
Input signal (%F.S.)
Input/output characteristics chart
ITV
Model
Pressure range
1 1000
2 2000
3 3000
Power supply
voltage
0
0 24 VDC
1
1 12 to 15 VDC
2
3
∗
4
∗ Option
Monitor output
∗
0 None (for preset input)
1 Analogue output 1 to 5V DC
∗
Switch output/NPN output
2
∗
Switch output/PNP output
3
∗ Option
1
Electro-Pneumatic Regulator
ITV1000/2000/3000
Series

Standard Specifications

Minimum supply pressure
Maximum supply pressure
Set pressure range
Power supply
Input signal
Input
impedance
Output signal
(monitor
output)
Linearity
Hysteresis
Repeatability
Sensitivity
Temperature characteristics
Output pressure
display
Ambient and fluid temperature
Enclosure
Weight
Note 1) Please refer to graph 1, relation to the differences between the set pressure and input.
Additionally, refer to the page 18 for the set pressure range by units of standard measured pressure.
Additionally, refer to page 18 as maximum set pressure differs on unit of standard measure.
Note 2) 2-wire type 4 to 20 mA is not available. Power supply voltage (24 VDC or 12 to 15 VDC) is required.
Note 3) Select either analogue output or switch output.
100
Further, when switch output is selected, select either NPN output or PNP output.
Note 4) The minimum unit for ITV205
Note 5) The above characteristics are confined to the static state. When air is consumed on the output side,
the pressure may fluctuate.

How to Order

3 0 1 0
1 0.1 MPa
3 0.5 MPa
Input
5 0.9 MPa
signal
Current 4 to 20 mA (Sink type)
Current 0 to 20 mA (Sink type)
Voltage 0 to 5 VDC
Voltage 0 to 10 VDC
Preset input
Thread type
–
Rc
∗
N NPT
∗
T NPTF
∗
F
∗ Option
ITV101
ITV201
Model
ITV301
Note 1)
0.005 to 0.1 MPa
Voltage
Power supply voltage 24 VDC type: 0.12 A or less
Current
consumption Power supply voltage 12 to 15 VDC type: 0.18 A or less
Note 2)
Current type
Voltage type
Preset input
Current type
Voltage type
Preset input
Note 3)
Analogue output
Switch output
Accuracy
Minimum unit MPa: 0.01, kgf/cm
ITV10
ITV20
ITV30
is 1PSI.
0 1 2
Port size
1 1/8 (1000 type)
2 1/4 (1000, 2000, 3000 type)
3 3/8 (2000, 3000 type)
G
1/2 (3000 type)
4
ITV103
ITV203
ITV303
Set pressure +0.1 MPa
0.2 MPa 1.0 MPa
0.005 to 0.5 MPa
24 VDC ± 10%, 12 to 15 VDC
4 to 20 mA, 0 to 20 mA (Sink type)
0 to 5 VDC, 0 to 10 VDC
4 points
250 Ω or less
Approx. 6.5 kΩ
Approx. 2.7 kΩ
1 to 5 VDC (Load impedance: 1 kΩ or more)
NPN open collector output: Max. 30 V, 30 mA
PNP open collector output: Max. 30 mA
Within ±1% (full span)
Within 0.5% (full span)
Within ±0.5% (full span)
Within 0.2% (full span)
Within ±0.12% (full span)/°C
±3% (full span)
2
: 0.01, bar: 0.01, PSI: 0.1
0 to 50°C (with no condensation)
IP65
Approx. 250 g (without options)
Approx. 350 g (without options)
Approx. 645 g (without options)
S Q
Pressure display unit
– MPa
2 kgf/cm
2
3 bar
4 PSI
5 kPa
Cable connector type
S
Straight type 3 m
∗
L Right angle type 3 m
∗
N Without cable connector
∗ Option
Bracket
–
∗
B
∗
C
∗ Option
ITV105
ITV205
ITV305
0.005 to 0.9 MPa
Note 4)
, kPa: 1
CE compliance
Q CE compliant
Without bracket
Flat bracket
L-bracket