Installing The Display Unit - Sony LY51 Instruction Manual

4-2. Installing the Display Unit

Since the LY51 display unit is designed to be mounted in line
measurement devices, you can mount the unit on a panel.
(See Fig. 1.)
1. Mounting the display unit on the panel
•
When you mount the display unit on the panel, cut out an
opening of the dimensions shown. (See Fig. 2.)
•
Mount the display unit on the panel using the supplied plate.
The display unit can be mounted from the front or back of
the panel. When mounting the display unit from the front of
the panel, remove the rubber legs.
Warning!
Use the supplied screws when attaching the plate to the
display unit. Using screws other than those specified may
damage the internal parts of the display panel and result
in electric shock.
2. When you use the unit as a stand-alone display unit
•
Position the display unit on the four rubber legs attached
to the bottom side of the unit.
Warning!
When removing and then reattaching the rubber legs,
be sure to use the screws supplied with the rubber legs.
Using screws other than those specified may damage
the internal parts of the display panel and result in electric
shock.
The LY51 display unit is classified as an INSTALLATION
CATEGORY II, POLLUTION DEGREE 2 device.
Fig. 1
Panel cut-out diagram
[Mounting the display unit from the panel front]
103/4.06"
+1
+0.04"
186
/7.32"
0
[Mounting the display unit from the panel rear]
103/4.06"
+1
193 /7.60"
0
Fig. 2
(Unit: mm/inch)
RESET REF
F
PRINT
LY51
MODE
REF PEAK
ENTER
POWER
220 /8.66"
4 – φ5.5/0.22" dia
0"
4 – φ5.5/0.22" dia
+0.04"
0"
115