Setting Up Connection To Instrument - TESTO 300XXL Instruction Manual

8
Preparation

Setting up connection to instrument

1. Connect the testo 300 XXL control unit
and the interface cable (Part no. 0409.0178) with a
serial interface (COMx) in your PC.
2. Switch on the control unit.
3. Start the Testo analysis software.
4. Select the "New device" dialog box from the
"Instrument" main menu. The "New device setup
wizard" dialog window opens.
5. Select the testo 300 XXL instrument driver and click on
"Continue".
6. Select a free interface and click on "Continue". The name of
the instrument driver is shown.
If the instrument is not connected, please check
the connection cable. Also check if the
configuration (COM1, COM2...) corresponds
If there are problems, close the programs which
have access to the serial interface.
8. You can select between the configuration for the
control unit or the analysis box in the
"Select device" window. The "Slave Mode"
is shown on the testo 300 XXL control unit
display. It is not possible to operate the control
unit keypad in this mode.
7. Click on "Finish" to set up
the connection to the control
unit. The instrument driver
appears in the directory. If you
wish to carry out changes, press
"Back" to return to the previous
pages.
to the interface in use.