Setting Up A Connection - TESTO 521 Instruction Manual

10
4. Programming

4.2 Setting up a connection

521 526
1 1 Start the testo ComSoft software.
2 2 Select I I n n s s t t r r u u m m e e n n t t > > A A u u t t o o d d e e t t e e c c t t . . . . . .
- The Autodetect (searching) window opens.
- A connection to the found instrument is set up
automatically and the name of the connection then
appears in the archive window.
- - o o r r - -
2 2 Select I I n n s s t t r r u u m m e e n n t t > > N N e e w w d d e e v v i i c c e e .
- The New device setup wizard window opens.
3 3 From the devices available, select t t e e s s t t o o 5 5 2 2 1 1 / / 5 5 2 2 6 6
and click on N N e e x x t t .
4 4 Under Connection, select the interface through
which you connected the instrument to your PC
and then click on N N e e x x t t .
5 5 Enter a name for the connection and click on
F F i i n n i i s s h h
.