Table of Contents
Advertisement
FLUSH MOUNT
Failure to properly engage the vehicle
parking brake prior to installing the lift-
gate may allow vehicle movement which,
if not avoided, could result in death or
serious injury.
NOTE:
Prior to installation verify the vehicle rear
doorsill will support required loads.
1. Remove bumper, step, or any protrusions that would
prevent your deck extension from being mounted flush
against the rear doorsill.
2. Follow the frame cutout requirements as shown for
your flush mount installation (Figures 8 or 9).
NOTE:
Flush Mount: Deck extension replaces the
rear sill and is mounted flush with the rear
frame posts
(Figures 8 or 9)
XL-TG10149IM-en-US Rev A 12-10 Amendments and Errors Reserved. © SAF-HOLLAND, Inc.
Figure 8
Figure 9
.
POST
9"
Frame Preparation
POST
5.38
9"
12"
27" for 36" Platforms
33" for 42", 45",47", 48"
52" & 61" Platforms
36" for TG3552 & TG3561 ONLY
5.38"
12"
27" for 36" Platforms
33" for 42", 45",47", 48"
52" & 61" Platforms
36" for TG3552 & TG3561 ONLY
Flush Mount
Truck Install
Flush Mount
Trailer Install
9
Advertisement
Table of Contents
