Table of Contents
Advertisement
Deck Extension Installation
5. Deck Extension Installation
Position of Deck Extension (Standard Mount Only)
1. Position and support the deck extension flush with the
rear doorsill of the vehicle. Ensure the deck extension
is flat and flush with the deck of the vehicle.
NOTE:
Some vehicles may be higher at the back
than the front or could be on unlevel ground;
therefore, the deck of the truck may be
sloped from the rear down to the front.
Ensure that the deck extension is parallel to
the truck deck.
2. The deck extension must be centered with respect to
the vehicle chassis. This ensures that the liftgate is
mounted on the centerline of the vehicle.
3. Tack weld into position.
4. Weld per Figures 10 and 11.
NOTE:
When welding is required, ensure that the
battery ground cable is disconnected and
that all electrical equipment is completely
electrically isolated before welding is
initiated.
Failure to isolate electrical equipment
from ground prior to welding could re-
sult in overload which, if not avoided,
may result in property damage.
10
Figure 10
1/4"
Figure 11
1/4"
XL-TG10149IM-en-US Rev A 12-10 Amendments and Errors Reserved. © SAF-HOLLAND, Inc.
TOP VIEW
TYP
1/4"
BOTTOM VIEW
TYP
2"-6"
1/4
2"-6"
RIB
Advertisement
Table of Contents
