Table of Contents
Advertisement
Hydraulic Hose Installation
8. Hydraulic Hose Installation
NOTE:
Packaged with your liftgate, you will find two
hoses of equal length.
IMPORTANT: Hydraulic hoses and hydraulic fittings
are shipped with end caps installed
which must be removed before
installation.
1. Connect a hose to the 'A' fitting on the main tube, feed
through the hole in the attaching plate, then connect
the other end to the 'A' fitting on the back of the pump
box (Figure 25, 26 & 27).
2. Connect a hose to the 'B' fitting on the main tube, feed
through the hole in the attaching plate, then connect
the other end to the 'B' fitting on the back of the pump
box (Figure 25, 26 & 27).
3. Install the supplied abrasion sleeve over both hydrau-
lic hoses and through the hole in the attaching plate.
16
Figure 25
A
Figure 26
Figure 27
XL-TG10149IM-en-US Rev A 12-10 Amendments and Errors Reserved. © SAF-HOLLAND, Inc.
ATTACHING
PLATE HOLE
A
B
B
Advertisement
Table of Contents
