Error Codes For Receiver; Measure For The Receiver - Akerstroms SESAM 800 Operating Manual

Error Codes for Receiver

13 Error Codes for Receiver
Any of the error states below is displayed with ten quick flashes on the Status
LED (LED6) regardless of fault.
• Id already programmed
• Memory full
• Memory card mismatch during power- up
• Memory card write error. Possible memory card removal during operation
• Memory card copy to verify error
• Internal errors, the unit needs service
• Line power unstable
14

Measure for the Receiver

Figure 21.
S800 DIN1 Operating Manual (original instructions)
Version: A1
92
The Sesam 800 RX DIN1 receiver measure
Document-ID: 954446-000 EN
Author: SH
17 (20)