Advanced Configuration; Erasing All Transmitters In The Receiver - Akerstroms SESAM 800 Operating Manual

Configuration of the Receiver
10.2 Advanced Configuration
This configuration allows the user to determine the function of the relay; mo-
mentary or remaining function. Note that this setting is possible only with the
first transmitter, the transmitter will be learned to the receiver at the same time.
Alternative after all transmitters has been erased, see section 10.3.
Momentary function: Hold in the transmitter button in order to activate the relay.
Remaining function: One press on the transmitter button to activate the relay,
ANT1
LED7
LED6
1. Press and hold down the Learn/Erase button (≈ 1 s) until LED7 is ON. The
Learn Mode will be active for 10 seconds. Press the Learn/Erase button
repeatedly until LED6 is indicating the desired function.
Momentary function: LED6 (status) is OFF.
Remaining function: LED6 (status) is ON.
2. Press the button on the transmitter that shall activate the relay in this
receiver. If the configuration is accepted by the receiver, LED7 flashes 3
times. Learn procedure is successful.
10.3 Erasing All Transmitters in the Receiver
1. Press and hold down the Learn/Erase button until LED7 is ON. The Learn
Mode will be active for 10 seconds.
2. Press and hold down the Learn/Erase button for about 5 seconds (until
LED7 is OFF). All transmitters are now erased from the receiver memory.
S800 DIN1 Operating Manual (original instructions)
Version: A1
P12
IC3
-
TP0
next press on the button will de-activate the relay (on/off).
LED7
LED6
B1
LED5
Learn/Erase button
REL1
+
D4
P1 P2 P3 P4 P5
Document-ID: 954446-000 EN
Author: SH
10 (20)