Immergas VICTRIX OMNIA Instructions And Recommendations page 27

5
4
3
2
1
The kit includes (Fig. 22):
No.1 Gasket (1)
No.1 Female concentric flange (2)
No.1 Wall sealing plate (3)
No.1 Aluminium tile (4)
No.1 Intake/exhaust concentric pipe Ø 60/100 (5)
No.1 Fixed half-shell (6)
No.1 Mobile half-shell (7)
Extensions for Ø 60/100 vertical kit (Fig. 23)
The kit with this configuration can be extended up to a max. verti-
cal straight length of 14.4 m including the terminal. This configu-
ration corresponds to a resistance factor of 100. In this case specif-
ic extensions must be requested.
Mounting the vertical kit with aluminium tile Ø 80/125
C
33 (Fig. 24)
7
1. Install the concentric flange (2) on the central hole of the boil-
6
2. Tighten the concentric flange with the screws in the kit.
3. Replace the tiles with the aluminium sheet (4), shaping it to
4. Position the fixed half-shell (5) on the aluminium tile;
5. Insert the intake-exhaust terminal (7);
6. Fit the Ø 80/125 concentric terminal pipe with the male side
22
C
33
The adapter kit includes (Fig. 24):
The Kit Ø 80/125 includes (Fig. 24):
23
To install the kit Ø 80/125 one must use the flanged
adapter kit in order to install the flue system Ø 80/125.
er, positioning gasket (1) with the circular projections down-
wards in contact with the boiler flange.
ensure that rainwater runs off.
(smooth) to the female side of the adapter (1) (with lip seals) up
to the end stop, making sure that the wall sealing plate (3) has
been fitted; this will ensure sealing and joining of the elements
making up the kit.
7
6
5
4
3
2
1
No.1 Gasket (1)
No.1 Adapter Ø 80/125 (2)
No.1 Wall sealing plate (3)
No.1 Aluminium tile (4)
No.1 Fixed half-shell (5)
No.1 Mobile half-shell (6)
No.1 Concentric intake-exhaust terminal Ø 80/125 (7)
The remaining kit components must not be used
C
33
24
27