Table of Contents
Advertisement
1
BOILER INSTALLATION
1.1
INSTALLATION WARNINGS
Operators who install and service the ap-
pliance must wear the personal protec-
tive equipment required by applicable
law.
This boiler has been designed for wall-mounted installa-
tion only; for central heating and production of domes-
tic hot water for domestic use and similar purposes.
The place of installation of the appliance and relative
Immergas accessories must have suitable features (tech-
nical and structural), such as to allow for (always in safe,
efficient and comfortable conditions):
- installation (according to the provisions of technical
legislation and technical regulations);
- maintenance operations (including scheduled, peri-
odic, routine and special maintenance);
- removal (to outdoors in the place for loading and
transporting the appliances and components) as well
as the eventual replacement of those with appliances
and/or equivalent components.
The wall surface must be smooth, without any protru-
sions or recesses enabling access to the rear part. They
are not designed to be installed on plinths or floors
(Fig. 1).
By varying the type of installation the classification of
the boiler also varies, precisely:
- Type B
or B
23
53
terminal for air intake directly from the room in
which the boiler has been installed.
- Type C boiler if installed using concentric pipes or
other types of pipes envisioned for the sealed chamber
boiler for intake of air and expulsion of flue gas.
Only professionally enabled companies are authorised
to install Immergas gas appliances.
boiler if installed using the relevant
Installation must be carried out according to regulation
standards, current legislation and in compliance with
local technical regulations and the required technical
procedures.
OK
It is not permitted to install boilers that are removed and
decommissioned from other systems.
The manufacturer declines all liability for damages
caused by boilers removed from other systems or for any
non-conformities of such equipment.
Check the environmental operating conditions of all
parts relevant to installation, referring to the values
shown in the technical data table in this booklet.
Installation of the boiler when powered
by LPG or propane air supply must com-
ply with the rules regarding gases with a
greater density than air (remember, as an
example, that it is prohibited to install
plants powered with the above-men-
tioned gas in rooms where the floor is at a
lower quota than the country level).
1
7
Hide quick links:
Advertisement
Table of Contents
