Replacing The Lamp - Kernau KFCF 1003 EW User Manual

REPALCE THE LAMP
The switch of LED lamp is gravity controilled, when the angle of door-opening is bigger than 30
degree, light will switch on and off when angle is smaller tha 30 degree.
NOTICE:
When LED lamp does not work when door is open, please be released and check as below steps:
• Firstly, loosen the screws on the lamp cover.
• Secondly, loosen the screws fixed on the lamp electronic parts
• Thirdly , check the cable terminals of electronic parts and terminals of contacting lines for door
lamp is loosening or not. Please fix them if they are not fixed. Then, check the light is on or not. If
the lamp is switch on please install the lamp cover. If not, please further check the electronic part is
intact or not. If necessary, please replace the electronic part to check the lamp is on or not. If the
lamp stilI does not work. Please contact with staft of after-sale service for assistance.
The steps of Led lamp installing
• Fix the cabie terminals of electronic parts and contacting lines in the door liner.
• Install LED electronic part in the door liner and fix on by screws.
• Install lamp cover on the holder and fix to finish all process.
EN 37