Expansion Cards And Expansion Card Risers - Dell EMC PowerEdge R250 Installation And Service Manual

Figure 47. Installing the heat sink
Next steps
1. Follow the procedure listed in
2. While booting, press F2 to enter System Setup and check that the processor information matches the new system
configuration.
3. Run the system diagnostics to verify that the new processor operates correctly.

Expansion cards and expansion card risers

NOTE: When an expansion card is not supported or missing, riser the iDRAC and Lifecycle Controller logs an event. This
does not prevent your system from booting. However, if a F1/F2 pause occurs with an error message, see Troubleshooting
expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
After working inside your system.
Installing and removing system components 53