Drive Backplane - Dell EMC PowerEdge R250 Installation And Service Manual

Figure 22. Installing the intrusion switch
Next steps
1. Install the air shroud.
2. Follow the procedure listed in

Drive backplane

This is a service technician replaceable part only.
Drive backplane
Depending on your system configuration, the drive backplanes supported for R250 system are listed here:
Table 10. Supported backplane options for R250 system
System
PowerEdge R250
Figure 23. 4 x 3.5-inch drive backplane
1. BP_PWR_1 (backplane power and signal cable to PIB)
2. BP_DST_SA1 (SAS/SATA connector)
After working inside your system.
Supported hard drive options
3.5-inch (x4) SAS, SATA backplane
Installing and removing system components 33