Dell EMC PowerEdge R250 Installation And Service Manual page 80

NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the right control panel cable to the connector on the system board.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 77. Installing the right control panel
Next steps
1. Install the air shroud.
2. Install the front bezel.
3. Follow the procedure listed in the
80 Installing and removing system components
After working inside your system.