Inside The System - Dell EMC PowerEdge R250 Installation And Service Manual

Table 2. Rear view of the system (continued)
Item Ports, panels, or slots
8 USB 3.2 Gen 1 port
9 USB 2.0 port
10 iDRAC ethernet port
11 VGA port
NOTE: For more information, see the Dell EMC PowerEdge R250 Technical Specifications on the product documentation
page.

Inside the system

Figure 5. Inside view of the system with backplane
1. Optical drive
3. Intrusion switch
Icon Description
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
This port is USB 3.0-compliant.
This port is USB 2.0-compliant.
Enables you to remotely access iDRAC. For more information, see
the iDRAC User's Guide at
Enables you to connect a display device to the system.
2. Backplane
4. Cabled power supply unit
button is enabled in the iDRAC setup.
the system ID button (for more than 5 seconds) to enter
the BIOS progress mode.
www.dell.com/poweredgemanuals
PowerEdge R250 system overview 9