Mitsubishi Electric MELSEC Q Series Handbook page 216

7
REPLACEMENT OF PROGRAM
Name
WDT setting
Initial execution monitoring time
Low speed execution monitoring time
Carry out battery check
Carry out fuse blown check
Carry out I/O module comparison
Computation error
Expanded command error
Fuse blown
I/O module comparison error
Special module access error
Memory card access error
Memory card operation error
Constant scanning
F No. display
Comment display
Occurrence time
Drive
File name
History No.
Low speed program execution time
I/O assignment
Boot file setting
Program setting
SFC program start mode
Start conditions
Output mode when the block is stopped
MELSECNET (II), /B
MELSECNET/10 (H)
MELSECNET/MINI
CC-Link
Ethernet
*1 For the number of mountable CC-Link modules and the number of settable parameters with the software package, refer to
the CC-Link System Master/Local Module User's Manual.
7
- 29
Compat-
ibility



The Universal model QCPU does not support the low speed program.







The name changes to "Intelligent module program execution error".





The QCPU does not incorporate this display function.

The QCPU does not incorporate this display function.

The QCPU does not incorporate this display function.

The storage location in the Universal model QCPU is fixed, therefore this setting does

not exist.


The Universal model QCPU does not support the low speed program.
Reviewing is required if the Q series CPU base unit has other than 8 slots.





Parameters are deleted, since the Q series CPU is not compatible with the

MESECNET (II), /B.
 Converted to the MELSECNET/10 mode.
Parameters are deleted, since the QCPU is not compatible with the MELSECNET/

MINI.
The number of settable parameters with the software package is eight.

Set the parameters of the ninth module or later with dedicated instructions.
The "Use the KeepAlive" of "TCP Existence confirmation setting" in the "Ethernet

operations" is automatically set.
Remarks
*1