Advertisement
Equipment list
Installation instructions
RM1 installation
TSG4100A Series RM1 and RM2 Rackmount Kit Instructions
Use the following tools to install the kit hardware:
Sockethead screwdriver
Torx T15 screwdriver
Torx T20 screwdriver
Torx T25 screwdriver
Flat-bladed screwdriver
These instructions are for personnel who are familiar with servicing the product.
If you need further details for disassembling or reassembling the product, refer to
the appropriate product manual. Contact your nearest Tektronix Service Center or
contact Tektronix Factory Service for installation assistance.
Use the following procedure and refer to the illustration to assemble the RM1
(single instrument) rackmount hardware and install the instrument into the rack.
(See Figure 3.)
CAUTION.
You must remove the feet from the bottom of the instrument if you
intend to install it immediately above another instrument in the rack (with no
clearance). To so this, you will need to use a flat-bladed screwdriver to pry out the
7/16"–deep plugs that cover the hidden screws, and then use a Torx T20 driver to
loosen the screws to remove the feet.
Installation instructions
5
Advertisement
