Installation Methods - Sinclair KJR- 90D Installation And User Manual

Please filed install the following accessory.
Number
Install box
1
Shielded 5-core cable
2
Wire configured tube (insulated
3
sheath)
Philips screwdriver
4
Slotted head screwdriver
5

3 Installation methods

The shielded 5-core wire pre-embedded into wall
1) Cut off the connective wires for the signal received panel (accessory) from the
middle (no protecting sleeve part), divide to be A, B parts and the A part has big
5-core connector as well as B part small 5-core connector.
2) Connect the big 5-core connector of the A part signal received panel connecting
wire group with the 5-core terminal of signal received panel, refers to the above.
3) Please connect the other side (cut-off side) of A part signal received panel with the
wall pre-bedded 5-core cable reliability, refers to the above.
4) Please connect the cut -off side of B part signal received panel with the wall
pre-bedded 5-core cable
reliability, refers to the right.
5) Insert to the bottom cover
to the electric cabinet by
the accessory slotted head
screws and take down the
bottom cover of wire controller
refers to the right.
6) Adjust the lenght of two plastic
bolts base on the length of through
Name
Connective wires for the signal received panel (accessory)
part A
Qty.
Universal electric cabinet specification,
1
pre-embed it into wall.
Pre-embed RVVP - 0,5mm
1
Pre-embed into wall, the longest
1
length should not exceeding than 15 m.
1
For unscrew the bottom cover of wire
1
controller.
8
Remark
Connectin
in digital d
connected
Signal received panel