Reely ROAD Deathwatcher Operating Instructions Manual page 42

 The vehicle doesn't drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
 Steering works opposite to the way the steering wheel is turned at the transmitter
• Check the steering reverse settings at the transmitter and switch them.
 Driving works opposite to the movement of the throttle/brake lever at the transmitter
Correct: The vehicle has to drive forwards when the throttle/brake lever at the transmitter is pulled towards the handle
and back when the throttle/brake lever at the transmitter is pushed away from the handle.
• Activate the driving reverse setting at the transmitter.
 The steering is not functioning or is functioning incorrectly, steering lock too slight on the vehicle
• If the transmitter offers dual rate settings, check these settings (observe transmitter's operating instructions). If the
dual rate setting is too low, the steering servo will no longer react.
• Check the steering mechanics for loose parts; e.g. check if the servo arm is properly attached to the servo. Also
check whether the steering mechanics is blocked, e.g. by small stones, sand, etc.
 Reversing does not work or does not work correctly
• The speed controller has a safety function. This way, reversing is only possible after the throttle/brake lever has been
put in the position for reversing for the second time.
If you drive forwards and then stop, for example (throttle/brake lever in the neutral position), and push the throttle/
brake lever away from the transmitter handle, only the red LED at the speed controller will light up initially. The
vehicle will not move, however.
If you put the throttle/brake lever in the neutral position again briefly and then push it away from the transmitter
handle a second time, the vehicle will drive backwards.
• Set the neutral position on the transmitter correctly by using the trimmer for the driving function.
42