Table of Contents
Advertisement
EN
18
Troubleshooting
12. TROUBLESHOOTING
Problem
The motor
will not start
Excessive
noise
Excessive
vibrations
Poor work
results
Possible causes
The machine is not connected to a
power supply
There is no voltage in the mains
Faulty power cord
Faulty safety switch/plug
Fuse against overheating was
activated
Blades are jammed
Leaking oil
Missing bolts, nuts or other parts.
The blades are damaged or worn out
Working depth is too large
Working depth is too small
Worn out blades
Remedy
Connect the machine to a power supply
Check the power supply
Check the power cord. Repair or replace it if
necessary.
Visit an authorised service centre
1. The working depth is too big, set a
smaller depth.
2. The blades are blocked, remove the
obstacle.
3. The soil is too hard, select the correct
working depth and move the machine
back and forth while reducing the
working speed. Wait approximately
15 minutes for the motor to cool down
before using it again.
Turn the machine off. Wait until the blades
come to a complete stop. Remove any
material stuck inside.
The tiller must be repaired. Call our customer
line for support.
Tighten all the parts. If the noise persists,
organise repairs.
Replace the damaged or worn out blades.
Set the correct working depth.
Set the correct working depth.
Replace the damaged or worn out blades.
FZK 2004 E
Advertisement
Table of Contents
