Batteries - Eagle AccuMap Sport Installation And Operation Instructions Manual

arrow key. The screen shown at right appears. Use
the up and down arrow keys to increase or de-
crease the airspeed. Use the right and left arrow
keys to change the track. Press the EXIT key to
erase these menus.
If you hold the left or right arrow keys down, the
track changes at 6° per second. You can change
this to 3° per second by moving the black box to
the "Turn Rate" label on the simulator setup screen,
then pressing the left arrow key.
When you're finished changing the track and
speed, press the EXIT key to erase the menus.
To turn the simulator off, press the MENU key, then
move the black box to the "Simulator Setup" label.
Finally, press the left arrow key.
Note: Your plot trail will be erased when you turn the simulator on or off.

BATTERIES

When using the AccuMap Sport with batteries, the backlights automati-
cally turn off after 30 seconds. (Remember, you can change the time
interval.) Pressing the PWR key turns the lights on again.
If the batteries become weak, the message shown
at right appears on the display. When the battery
voltage drops below a certain level, the unit auto-
matically turns itself off. A message shows on the
screen about a minute before it shuts down.
When switching from external power to the batter-
ies, a tone sounds which alerts you to the fact that
you're now on battery power.
Store your unit with the battery pack attached. Do not remove the batter-
ies. This will increase the internal memory's battery life.
60