Cadel LORD 7 Installer Manual page 31

PROBLEM CAUSE
Not sufficient
combustion air
Flames are weak
Obstructed exhaust
and orange colou-
red, pellets do not
burn properly and
the glass blackens
Obstructed stove
The fume fan is out
of order
Faulty fume tem-
The exchanger
perature probe
fan continues to
turn even though
the stove has just
Faulty mother
cooled
board
Faulty or out of
order door gaskets Replace the gaskets.
Ash remains along
the stove
Not sealed fume
pipes
The stove is at its
Ambient tempera-
highest power but
ture reached.
does not heat up.
Stove running and
Reached fume
display showing
outlet limit tempe-
"Smoke Overtepe-
rature
rature"
The stove's smoke
Low smoke tempe-
duct produces
rature
condensation
STUFE A PELLET
SOLUTION
Check as following: probable obstructions of the combusti-
ble air inlet from the back or from the bottom of the stove;
burning pot obstructed holes with too ash remains. Have the
fan blades and auger cleaned.
The exhaust chimney is partially or totally obsturcted. Contact
an expert stove-repairer who checks the stove from the
exhaust up to the chimney pot. Provide immediately for stove
cleaning.
Provide immediately at the inner cleaning of the stove.
The pellets can burn also thanks to chimney flue depression
without the aid of the fume fan. Have the fume fan imme-
diately replaced. It can be noxious to health to let the stove
running without fume fan.
Replace the fume probe.
Replace the mother board.
Contact an expert stove-repairer who will immediately pro-
vide for sealing the junctions with high-temperature silicone
and/or for replacing pipes with those in compliance to current
regulations. A not sealed fume channelisation can be noxious
to health.
The stove is at its minimum value. Increase the desired am-
bient temperature.
The stove runs at minimum. NO PROBLEM!
Check that the flue is not clogged.
Increase stove power to minimum (pellet drop and fan revs).
Install condensation collection cup.
INTERVENTION
31