Table of Contents
Advertisement
Chapter 1
Onboard IDE
Supports Independent timing of up to 4 drives
l
Supports Ultra ATA 100/66/33, PIO mode
l
Supports Two fast IDE interfaces which can support four IDE devices including IDE
l
hard disks and CD-ROM drivers
USB Ports
2 USB Host Controllers with total of 6 ports
l
USB 1.1 compliant
l
Supports wake-up from S1 (power on suspend), S3 (Suspend to RAM,depends on
l
device)
Onboard I/O
l
One floppy port supports up to two 3.5
1.44M/2.88M format
Two high speed 16550 compatible UARTs (COM1/COM2/COM3/COM4 selective) with
l
16 byte send/receive FIFO
One parallel port supports SPP/EPP/ECP mode
l
Infrared interface
l
All I/O ports can be enabled/disabled in the BIOS setup
l
Onboard LAN (Available onS4L-L,S4L-AL mainboard)
l
10/100 Mbit/sec Ethernet support
l
10/100M LAN interface built-in on board
Onboard Audio (Available on S4L-A,S4L-AL)
AC'97 2.1 Specification Compliant
l
Provides onboard Line-in Jack, Microphone-in Jack, Speaker-out Jack with onboard
l
amplifier and MIDI/Joystick Connector
AGP Interface(Optional)
AGP Connector supports AGP 2.0 including AGP 4x data transfers
l
Graphics Card above SIS315 is suggested strongly to be equipped on the mainboard
l
BIOS
Licensed advanced AWARD(phoenix) BIOS
l
l
Supports Flash RAM with plug and play ready
l
Supports IDE CD-ROM or SCSI boot up
2
"
"
or 5.25
floppy drives with 360K/720K/1.2M/
Manual for S4L series
Advertisement
Table of Contents
