Panasonic PAW-160MAH2L Installation Instructions Manual page 103

Changing values in the "Parameter" menu
To change the values of control parameters, perform the following steps:
1. Press and hold the
S S E E T T
The PV display shows "ALI", while the current setting in the SV display is blinking.
Note: After 30 seconds of idleness, the display automatically returns from parametrization view
to normal view.
2. Press the
S S E E T T
The sequence of parameters and their range of valid values are shown in the table below.
3. Once the PV display shows the parameter to be changed and the blinking SV display shows
the currently set parameter value, use the
value
S S E E T T
4. Confirm the new setting by pressing the
S S E E T T
5. If more than one parameter needs to be changed, repeat steps 2 through 4 for each required
parameter.
6. Once all parameters are set as required, confirm the complete parametrization by pressing and
holding the
S S E E T T
9
Parametrization is now complete. The PV and SV displays have returned to showing the current
temperature and the set temperature values respectively.
AHU Kit – Installation Instructions – 09/2021
S S E E T T
button for approximately 3 seconds to enter the "Parameter" menu.
TR-16e
1 x for 3 sec.
S S E E T T
button repeatedly to select the parameter to be changed.
TR-16e
repeatedly
TR-16e
TR-16e
1 x briefly
S S E E T T
button for approximately 3 seconds.
TR-16e
1 x for 3 sec.
, and buttons to set a new parameter
S S E E T T
button.
Control
7
103