Angular Cutting; Single Head Cutting; Display Counter Reset - YILMAZ KD 402 Manual

7.2.5 Start the motor by pressing the motor start buttons (FIGURE 3, NO. 75/2) located on the control panel following
the fixing procedure.
7.2.6 Start the cutting procedure by simultaneously pressing the cutting buttons (FIGURE 3, NO. 75/5) and hold them
pressed until cutting operation is completed.
7.2.7 Release the pressure on the button at the end of the cutting operation. Both cutting units shall return to starting
position.
7.2.8 Stop the motor by pressing the motor stop buttons (FIGURE 3, NO. 75/2).
7.2.9 In case of a potential danger release the pressure on the cutting buttons or press the emergency stop
button (FIGURE 3, NO. 75/3).
7.2.10 Remove the part by opening the clamps.
Don't operate the saw while it touches the work piece. The saw must be operated only when the head
is in the top position.

7.3 Angular cutting

7.3.1 Release the lock by moving the table lock shaft (FIGURE 4, NO. 52) leftwards.
7.3.2 Pull the spring shaft (FIGURE 4, NO. 50) out from the spring seat. Simultaneously, move the saw head
(FIGURE 3, NO. 4) to the desired angle by using the plastic lever (FIGURE 3, NO. 156) with your other hand.
You can read the angle values by means of the angle measure found on the table (FIGURE 3, NO. 2).
7.3.3 Angles of 15 – 22.5 – 30 and 45 can be set by means of the spring (FIGURE 4, NO. 50) while other
intermediate angles can be set by means of the table lock shaft (FIGURE 4, NO. 52). The spring shall not fit into
the seat in intermediate degrees. Tighten the table lock shaft by pushing it rightwards after rotating the saw
head to the desired angle.
7.3.4 Carry out the cutting operation after.

7.4 Single head cutting

7.4.1 Select the unit to make cutting with single saw head. (Fixed or mobile cutting unit)
7.4.2 Make the saw rotate by pressing the motor start button (FIGURE 3, NO. 75/2) located on the cutting unit which
starts the motor. In this mode, the machine is adapted to perform cutting operation only on the desired unit.
7.4.3 Press the cutting buttons (FIGURE 3, NO. 75/5) simultaneously and keep them pressed until the work piece is
cut. From the worker safety viewpoint, the cutting operation is adapted to incorporate double hand control. The
saw head under use moves during cutting operation with single saw head. The other cutting unit remains
stationary.
7.4.4 Carry out the cutting operation after.

7.5 Display counter reset

7.5.3 Move the movable head so that it touches the fixed head (Ensure that the
movable head touches the adjustment bolt on the fixed head.)
7.5.4 Reset the measurement by simultaneously pressing the F and SET buttons
onthe display.You should read the measurement 530. If the cutting measurement
is wrong, adjust it by turning the adjustment bolt to the right or left.
25