Angular And Run Out Adjustment Control Of Saw Blade And Set Square; Adjust The Air Pressure; Noise Emission Values - YILMAZ KD 402 Manual

8.3.5 Get the belt tension part (FIGURE 2 NO.155) to off-position by turning it with the aid of a switch, have the belt
(FIGURE 2 NO.185) got loosen by pushing the motor (FIGURE 2 NO.29) forward.
8.3.6 Change the new belt with the previous one. Be careful when fixing the belt to the channels of balancing wheel
(FIGURE 2 NO.24/33) of the channels of the belt.
8.3.7 After having fixed the new belt to its place, set the tightness of the belt by holding the belt tension part (FIGURE
2 NO.155) with the aid of 12 mm switch. After adjusting it to the proper tightness, tighten M16 nut (FIGURE 2
NO.157) with your free hand while still holding the part.
8.3.8 Tighten the motor connection bolts. (FIGURE 2 NO.176)
8.3.9 Fix the removed parts by following the reverse sequence that your removed them before.
8.4 Angular and run out adjustment control of saw blade and set sguare
8.4.1 Cut the electric connection of the machine.
8.4.2 Control the run out of the saw blade with eyes. İf possible use a dial gage.
8.4.3 If there is any problem in the inclined cut, control the saw's 90 degrees orthogonal to the set square with the aid
of the set-square. If it is not proper, loosen the stay bolt at the top which tightens the spring (FIGURE 4 NO.50)
Have the pin located to its place by turning the spring in way that it can provide it to be proper by setting it to the
90 degrees. Tighten the screw at the top again which fastens the spring.
8.5 Adjust the air pressure (pneumatic systems)
8.5.1 Pull up pressure adjustment valve. Set adjustment valve
to the desired value on manometer by turning it clockwise
or counter clockwise. Then lock the valve by pressing it
down.
8.5.2 Set the air pressure between 6 and 8 BAR. If air pressure
drops below the stated values, accessories operating with
pneumatic power do not work.
8.5.3 Conditioner unit accumulates the water in the air in the
collection container so that it won't damage pneumatic
components. At the end of the working day, empty the
accumulated water by opening water discharge valve
under the collection container.
8.5.4 In order to put oil to the oil tank, remove the reservoir by
turning. Oils recommended by the manufacturer are;
TELLUS C10 / BP ENERGOL HLP 10 / MOBIL DTE
LIGHT / PETROL OFİSİ SPINDURA 10.

9. NOISE EMISSION VALUES

Educations including possible effects of noise to hearing sense, purposes advantages, disadvantages,
usages and determination of protection types, maintenance and cleanless of earflaps must be given to the
operator who works at the noise level greater than 80 dB(A) before he/she begins to work. It is
recommended to be renewed these eduacations
Characteristic informations of machine :
Rotation speed of saw : 3000 rpm
Motor power : 2.2 Kw
Nominal voltage : 400 V
Specifications of filing evacuation manifold:
Diameter : 65 mm.
Characteristic values of saw :
Saw diameter : 400 mm
Saw thickness : 4.2 mm
Shaft thickness of saw : 3.2 mm
Saw forward movement speed (According to aluminium material) : 64 m/sn.
anually.
29