Multicast Test - Ebyte E180-DTU User Manual

Chengdu Ebyte Electronic Technology Co., Ltd
(2) After the target MAC address is configured, you also need to configure the transmission mode, change the
"network address (short address)" to "MAC address", and then write the parameters again. At this time, the target address
is configured for unicast in the form of MAC address.
(3) After completing the above parameter configuration, you need to click to enter the transmission mode and
communicate in the transmission mode.

7.3.2 Multicast test

(1) For example, the terminal device is the receiving end, click "Enter configuration mode", modify the network
group number to "5", and then write the parameter, and the message box prompts "The parameter was successfully
written". At this time, the terminal device is assigned a group ID of 5.
Copyright ©2012–2019,
C
hengdu Ebyte Electronic Technology Co.,Ltd
E180-DTU(ZG120-485) Usermanual
28